I turned off the connection between multicharts and IB Gateway. After I reopen it and expect there is a trade. The "TIF not specified" signal was noted. and the message from the trade log is " Didn't receive final status for order OrderID = 52 ................" . I checked my setting in IB Gateway, I found that the box of API read only mode is clicked. But I still have trade before I turned it off last week.
Did anyone have experienced similar problem. is IB gateway always turn itself back to read only mode after restart?
TIF not specified.
- Henry MultiСharts
- Posts: 9165
- Joined: Aug 25 2011
- Has thanked: 1264 times
- Been thanked: 2958 times
Hello dingmanhoe123,
If you are running a demo account then the recent versions of IB Gateway/TWS reset the settings upon restart. If you are running a sim/live account then this should not be the case. If you switch between accounts then each of them should have individual set of application settings.
If you are running a demo account then the recent versions of IB Gateway/TWS reset the settings upon restart. If you are running a sim/live account then this should not be the case. If you switch between accounts then each of them should have individual set of application settings.
- Henry MultiСharts
- Posts: 9165
- Joined: Aug 25 2011
- Has thanked: 1264 times
- Been thanked: 2958 times
dingmanhoe123, if your IB Gateway settings are reset after restart - you need to contact IB support for assistance.