Dear All,
Is there a Powerlanguage function to tell what resolution the chart is running?
For example: the chart is plotting GBPUSD, with a resolution of 6 points.
I want write a signal that says: if low is above (chart resolution, so 6 points) of moving average then plot1(blablabla)
Many thanks,
[PL] How to tell PL what resolution the chart is?
- TJ
- Posts: 7774
- Joined: Aug 29 2006
- Location: Global Citizen
- Has thanked: 1036 times
- Been thanked: 2233 times
press [F1] key in MultiCharts,
Under PowerLanguage > Keyword Reference,
look for Data Information/General
keywords:
BarInterval
BarType
BarType_ex
Under PowerLanguage > Keyword Reference,
look for Data Information/General
keywords:
BarInterval
BarType
BarType_ex
- TJ
- Posts: 7774
- Joined: Aug 29 2006
- Location: Global Citizen
- Has thanked: 1036 times
- Been thanked: 2233 times
you are welcome !
it is good to know you have found what you needed.
it is good to know you have found what you needed.